viair 92820 6 Puerto Colector Con Orificios de montaje

Used for air ride distribution off air tank to supply 4 valves. Makes everything seem neat and compact instead of a mess of coupling and various adapters. Makes things much simpler. Nice product and no problems whatsoever with threading as it's standard NPT

This manifold is super well made, and it's unique -- it comes with a bracket, and cross-drilled holes that allow you to mount it almost any way you want. In my opinion, it's also a vital component to anyone doing a permanent air compressor installation in their vehicle. My use for this Viair manifold is in my 2009 Toyota Tacoma 4x4 to handle my custom tire inflation system. The whole unit is both necessary and excellent for my needs, but with one major caveat...The substantial issue I noted in the headline is that the NPT threads are far too tight and the hole begins to taper far too early in the threads. I'm using brass NPT fittings, and they only get a few threads in before tightening up to the point they can't be tightened any more (at torque limit). Not an issue if only a few threads

It is what it is and works as it should. As far as the reviews saying it wasn't threaded right, the one I recieved had no issues with the thread. Have it plumbed to my truck, I have the compressor discharge with a check valve, compressor shut off, quick connect fitting and outlet to the tank and holds air without leaks.

Unfortunately, this block is a fantastic idea. Using it for my onboard air system and installed one quick couple and the rest were plugged and one port used for supply. Horrible all ports leak. Going to add a valve for when in use. Sad great idea poor quality on the thread tolerances.

The taps on my was good. Was able to fit 4 ball valves on them but had to disassemble 2 of the 4 ball valves and remove the stem so the valve body will clear each other when screwing in. Also had to mount the valves in an angle so the lever will clear each other and had to grind down the bottom of the lever at an angle as well. Overall, very happy with it. Very compact. Using it as a vacuum manifold to distribute vacuum on my vacuum table.

Unlike some of the other experiences detailed in these reviews, the manifold I received was within advertised specifications.It was well packaged and all Allen screws, washers and nuts were in a separate, sealed bag. The coating is uniform and covered the entire manifold.1/4 NPT fittings threaded in smoothly and to the appropriate depth, with 2 wraps of teflon sealing tape around the threads.For those who will use this as an OBA (On Board Air) manifold and to house ARB locker solenoids. The manifold is compact and the holes are too close together to install ARB solenoids side-by-side; they must be separated by at least one hole. I set mine up like so (from left to right, looking at the manifold): side hole closed with 1/4" NPT hex plug | ARB solenoid #1 | in-cab pressure gauge hose …

Purchased to fabricate a distribution manifold for my Pond's Aeration System. Pleasantly surprised at the noticeable heft, and build quality of this part. Threading on mine is deep, clean, and tight across all 6 ports. So don't worry too much about having to chase them yourself to make your gear seat and work properly. Detachable Mounting bracket is spot-on perfect for my purposes in attaching this D-block firmly to the compressor cabinet. As a carpenter, I'm sure this would also work like a champ rigged to a rolling hot dog or any high volume compressor onsite for the crew. The front facing 1\4" outlet ports are spaced more than enough so you could run 4 beefy quick-connect couplers in line with ease and without frustration. Also love having the two side ports to use as the inlet, and …

This works excellent! I used it to create a manifold for my compressor. All the parts were good just the manifold was cracked, and the OEM is no longer made. This guy worked great and I love the mounting bracket. You can change the position that it attaches to the block. So cool.