Faros antiniebla: transparentes (kit de cableado y bisel incluidos) para Toyota Tundra 07-12

Great kit, love them.

Love these on my truck. They hooked right up and work great. (07 tundra)

I was able to use this kit to replace the damaged factory fog lights in my 2010 Tundra. Since the wiring was in place already, all I needed was to pop out the old and pop in the new. It fit perfectly and connected with factory harness. The lights are very bright as well.

This would have been a great kit but the three plastic handles on the bulb housing did not line up with the holes insides the bumper, so I had to break them off to get the housing to fit inside the bumper correctly. The biggest problem I had with this kit was trying to find power for the switch inside the truck. The simplest thing to do is to get a 12 volt Circuit tester from an Advanced Auto store for under $10, remove the kick panel, and use the circuit tester to determine which wire is hot when you turn the ignition switch on. Tap into that wire with the red wire of the switch after you have grounded the switch with the black wire. As commented by others, the switch light should have been amber in color to match the factory lighting and not a neon green. In the end, the fog lights work

The entire system works but a few changes need to be made. One of them is the ugly green switch that comes with it. Another thing is the lack of a proper wiring protector. Things got tight and I was not able to put the Fuse inside the fuse box due to wire shortage.

Bought this set for my 2007 Toyota tundra and they fit perfectly, ran the new wiring harness with switch with no problem. Lights are nice and bright. The switch is a little too bright but can deal with it. Quality product for the cost.

Fits in the stock steel bumper fog light pockets like factory, plugs into factory fog light wires that were taped up behind the bumper. Add an OEM fog light relay and OEM fog light switch turn signal stalk and you have OEM fog light setup for under $150!

I bought this light kit not knowing what to expect about quality and installation but compared to what else I saw out there they seem like a good gamble. The light fixtures popped in and bolted up in about 15 minutes. I ran the wiring starting with the fixtures and worked my way back up toward the battery securing everything as I went. I was able to fish the power wire leading from the switch to the light harness through the main wiring harness grommet on the firewall. This took me about 30 minutes to this point. I installed the switch in the factory location in about 5 minutes, then I found a good ground location, secured that wire, located a 12v switched hot lead under the kickboard and attached my switch hot lead. Lights worked great, look great and were a fantastic price.